Buy Honda Outboard Parts

Announcement

Collapse
No announcement yet.

'03 225 Not holding trim position

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • '03 225 Not holding trim position

    My BF225 is not holding Trim.

    I had the trim assembly replaced 2 - 3 years ago.

    This past week I started noticing that after I trimmed the engine up while running it was moving back down.

    could this be a fluid level - btw....what type of fluid to add if its low and what is the best way to add trim fluid ?

    or....am I looking at a problem with seals and a rebuild or replace again ?

    Thanks
    Bill

  • #2
    Note: I am going to head over to the marina and check the tightness of the manual release valve / screw for the tilt/trim.

    Comment


    • #3
      Might check the manual release and fluid level with motor tilted up all the way. If oil is foamy then may need to bleed air out of hydraulic system.
      Regards
      Boats.net
      Honda Outboard Parts

      Comment

      Working...
      X