Honda   Honda Outboard Parts
 
Honda Outboard Forum Honda Outboard Parts Discussion Forum Honda Outboard Parts Boat Parts Honda Outboard Forum Outboard Motor Parts Contact Us
Honda Parts
  #1 (permalink)  
Old 04-01-2011, 04:14 PM
Junior Members
 
Join Date: Mar 2011
Posts: 4
Default Newbie with questions of course

Been reading this forum for a couple weeks, figured I better join up.
Always had good luck with anything Honda so I figured I would repower my boat with one.


I just purchased a used bf150 with out controls switch or wiring harness.

Just bought a key switch with lights part number 32340-ZW5-013

Still need wiring harness from motor to the switch and cannot find exactly what I need. I know the engine has a 16or14? pin round and a 6 pin connector. I looked on hondas accy brouchure and looks like I need a

06325-zw5-u00
32580-zy3-000

any help welcomed need this to test engine before installing.
Was looking on ebay for a harness but alot of different part numbers were listed.

Scott
Reply With Quote
  #2 (permalink)  
Old 04-02-2011, 04:12 PM
Junior Members
 
Join Date: Oct 2010
Posts: 53
Default

I would get the 20 wire harness...33205-ZY6-020AH (20ft). If you need a 25 ft cable then the last numbers would be 025AH. A 30 footer would be 030AH. I think you will find it is probably cheaper and does more than the harnesses that you listed.

I think the key switch panel you ordered is an older still, that is not sold by Honda anymore. It probably just has an overheat and an oil pressure light.

You should also install a PGM light panel which is a check engine light and a charge light. Its number is 32340-ZW7-000AH. It runs around $30. It is useful to let you know when there is a sensor or charging problem.

The harness mentioned above, has all the wiring needed to handle the PGM panel (just plug it in).

Mike
Reply With Quote
  #3 (permalink)  
Old 04-03-2011, 12:39 AM
Junior Members
 
Join Date: Mar 2011
Posts: 4
Default

Thanks for the reply Mike. I will look for the harness monday at the dealer I searched the web for that part number and get nothing for some reason.
I seen the PGM Panel and figured that was going to be the two lights on the key switch panel I bought but was wrong.

The switch panel is a little bigger than what I wanted but will work.

Also should have mentioned the motor is a 2005 don't know if that makes a difference. I was looking at gauges mostly likely will go aftermarket set of analog type.

One other question, I may be wrong but I belive I read that my motor can support those digital gauges with everything reads on just two gauges.

Scott
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


All times are GMT -4. The time now is 11:49 AM.

Outboard Parts

Other Forums
Yamaha Parts
Suzuki Parts
Evinrude Parts
Johnson Parts
Mercury Parts

Copyright © 2000 - 2012, Outdoor Network LLC