bf30a carb isssues
I have a 96 30hp honda on a 16ft skiff
The motor sat for a couple years while boat was repaired
I pulled carbs and tore um down soaked um in gas blasted um with air and a can of carb cleaner each and put um back together with new gaskets
It ran fine in the yard but under a load on the water it starts good but stalls when powering up
if i do get it up it runs good wide open for a few minutes than bogs down and runs ruff
I replaced the fuel hose, bulb, gas tank and put fresh gas in but it did not help
about 5 years ago i cleaned the carbs the same way and it ran great until the boat sat for repairs
What am i doing wrong
Does the jet have to seat in the nozzle a certain direction to allow holes to spray properly(maybe I just got lucky last time)
Should i soak um in something else ?maybe a ultrasonic hot water bath
Am i totally off could it be a fual pump it seems to be working?
Thanks in advance
|
Linear Mode
